• Increase font size
  • Default font size
  • Decrease font size
Start Antenna Distributors AVS Series Antenna Distribution System AVS Series

Antenna Distribution System AVS Series

Print
Article Index
Antenna Distribution System AVS Series
Technical Data
All Pages

Flexible Antenna Distribution Solution

Non-blocking Switching 10 kHz - 30 MHz

Upgradeable: 16 Antenna Inputs to 120 Receiver Outputs

Configuration According to Customer Specification

 

 

Description

The AVS is a very flexible antenna distribution solution for short wave communication applications. The standard version furnished into a single 19-inch 4 HU slide-in unit provides up to 8 antenna inputs and up to 40 receiver outputs.

The system can be extended to provide the distribution of up to 16 antennas to 120 receivers. Such system consists of a master unit (8 inputs and 40 outputs), to which slave units, pre-distributors and/or relay matrices are added dependent on the extension stage.

The master unit controls all equipment connected and sets up the connection with the computer via RS232/RS422 or optionally via LAN interface.

Relay matrices are added if more than 8 inputs are needed.

Active pre-distributors are applied if more than 40 outputs are required. They distribute in each case 8 inputs to 3x8 outputs so that further antenna distributors can be connected in parallel.

The system will be configured according to customer needs.

 

Antenna Distribution System AVS


Features and Options

  • The standard frequency range is 1.5 to 30 MHz.
    Optionally the frequency range 10 kHz - 30 MHz is supported for some or all inputs.
  • For highest flexibility the system supports between 4 and 16 inputs (in steps of 1) and between 10 and 120 outputs (in steps of 10).
  • The integrated operating and control unit monitors all functions of the system and allows the local operation of the antenna distribution system. In the event of a failure an acoustic warning signal is audible.
  • A Ethernet 10/100 LAN interface can be used instead of the serial interface.
  • The transferred data (switch commands) are stored. So after a power failure or turning off the system the previous switching status will be resumed automatically.
  • For higher operational reliability the system supports redundant control units
  • Redundant power supply units are supported.
  • The antenna distribution system can also be delivered mounted into a 19 "rack ready for operation.

 

 



 

(c) 2011 AAS GmbH. All rights reserved. Design and administration by ancomi